[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: gEDA: pcb batch mode

To: geda-dev-at-NOSPAMseul_dot_org
Subject: Re: gEDA: pcb batch mode
From: DJ Delorie <dj-at-NOSPAMdelorie_dot_com>
Date: Mon, 15 May 2006 10:22:43 -0400
Delivery-Date: Mon, 15 May 2006 10:22:56 -0400
In-reply-to: <20060515141501.GB12638@kestrel.barix.local> (message from KarelKulhavy on Mon, 15 May 2006 16:15:01 +0200)
References: <200605150104.k4F14VXI012844@envy.delorie.com> <44686056.9010809@mcmahill.net> <20060515141501.GB12638@kestrel.barix.local>
Reply-To: geda-dev-at-NOSPAMseul_dot_org
Sender: owner-geda-dev-at-NOSPAMseul_dot_org


> Is it possible to invoke the export command in the batch mode? If
> yes, then how or where can I read about how to do it?

Did you read my other email about exporting from the command line?

References:
- gEDA: pcb batch mode
  - From: DJ Delorie
- Re: gEDA: pcb batch mode
  - From: Dan McMahill
- Re: gEDA: pcb batch mode
  - From: Karel Kulhavy

Prev by Date: Re: gEDA: pcb batch mode
Next by Date: gEDA: o_pin_end(): connection check and drawing
Prev by thread: Re: gEDA: pcb batch mode
Next by thread: gEDA: o_pin_end(): connection check and drawing
Index(es):
- Date
- Thread