Re: gEDA-dev: pcb compile from cvs with docs question

[Dan McMahill <dan-at-NOSPAMmcmahill_dot_net>]

John Griessen wrote:
> Hi y'all,
> 
> I got a good compile of pcb without docs, so then I tried again adding the
> 
> --enable-maintainer-mode flag to ./configure
> 
> It goes and stops as below.
> 
> What is rule to make target `pcb.html', needed?
> 
> John G
> 
> 

> make[2]: *** No rule to make target `pcb.html', needed by `all-am'.  Stop.

I'm suspicious that you have an automake which is too old.  Which 
versions of automake and autoconf do you have?  The file README.cvs 
should give some guidance (although not absolute) on required versions. 
  Such are the joys of tracking cvs sources instead of building from the 
snapshots.  I suppose it's probably about time for another snapshot.

-Dan



_______________________________________________
geda-dev mailing list
geda-dev@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev