Re: gEDA-dev: Re: [Gnucap-devel] Gnucap docs build failure on FC5(and other places)

[Dan McMahill <dan-at-NOSPAMmcmahill_dot_net>]

John Griessen wrote:
> This paragraph would be helpful in the README.cvs file
> 
> John G
> 
> Dan McMahill wrote:
> 
>>
>> When the build system is used to generate the distfile ('make dist' or 
>> preferably 'make distcheck') then the .dvi, .pdf, and .html versions 
>> of the manual are included in the distfile.  If you do not use 'make 
>> dist' or 'make distcheck' to build the distfile, then all bets are off 
>> because you'll have a mismatch between what you've told the build 
>> system and what files you've actually provided.
> 


last I looked it didn't look to me like gnucap (which is what this 
thread was about) uses cvs and the only way to get sources is via the 
snapshots.


If you are talking about PCB, README.cvs has:


==========
If you do not wish to build the documentation, use --disable-doc when 
you run configure.  If you do wish to build the documentation, you 
should enable maintainer-mode (--enable-maintainer-mode) which will turn 
on various dependency rules for documentation building.  In addition you 
must build pcb with the png export HID enabled (it is enabled by 
default) because some of the figures in the manual are drawn with pcb.
==========



_______________________________________________
geda-dev mailing list
geda-dev@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev