Re: gEDA-dev: [PCB] bugreport: ./configure vs yacc

[Dan McMahill <dan-at-NOSPAMmcmahill_dot_net>]

Igor2 wrote:
> Hi!
> 
> Today I tried to compile PCB on a different host. After many iteration
> with ./configure (why can't it tell all the things it will need
> later...)

if "it" is the configure script, I believe it does tell you when it 
can't find a required bit.  If "it" is the "INSTALL" document then I 
think it does list the dependencies and the "README.cvs" document I 
think does list everything you need if you are building from cvs sources.

So, which pcb are you building?  Is it a snapshot (which one) or cvs 
sources (from what date)?

Are there specific things missing from the 2 documents which I need to add?


 > I finally had a system which it liked. However, make failed very
> soon because of missing yacc.
> 
> Shouldn't ./configure look for yacc?
> 

it does, but upon further inspection it doesn't error out with a missing 
yacc.  Could you provide the exact error which was produced?

Thanks
-Dan


_______________________________________________
geda-dev mailing list
geda-dev@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-dev