Re: gEDA-user: I need to open and print a PCB created inExpressPCB:What are my options?

["Mark Rages" <markrages-atMUNGEDgmail_dot_com>]

On 1/29/07, Jeremy Pedersen <ubernerd.jeremy@gmail.com> wrote:
> So it's possible to hand solder or reflow these things at home? Better yet,
> can you do double sided SMT boards? I always thought you coudn't do it
> because you would have to have components touching the surface of the reflow
> skillet on one side while the other side was supposed to reflow. Also, am I
> right to suppose that since you use gEDA that there are footprints in gEDA
> for SMD components?
>
> That's something I hadn't thought of. I do have a school e-mail address, so
> I will check out On-semi.
>
> I couldn't really tell you if this is a particularly weird MOSFET. We just
> started semiconductor devices at school, so I'm really only familiar with
> Diodes so far. Here's the part at both Digi-Key and Mouser:
>
> Mouser ) 511-STN1NF10
> Digi-Key ) IRLD110-ND
>

Try the lead-free version: $1.95 in single piece qty: IRLD110PBF-ND

Regards,
Mark
markrages@gmail
-- 
You think that it is a secret, but it never has been one.
  - fortune cookie


_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user