[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: gEDA-user: Panelizing methods?

On 2/1/07, Lares Moreau <lares.moreau@gmail.com> wrote:
> Heya List :)
>
> Any suggestion on the best way of makeing seperations in a panel using only the drillholes > available on the cheaper PCB services.  I was thinking of placing a bunch of .090" holes > .100" apart. Then it's a snap and file when the panel gets here.

Check with your PCB service to verify that they allow perforations
(and panelizing).
Some don't.

I usually draw silkscreen lines 100-150mils from the edge of the board and
use a bandsaw or a hacksaw.

(* jcl *)


-- 
http://www.luciani.org


_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user