Re: gEDA-user: gsch2pcb problems - I think!

[Dan McMahill <dan-atMUNGEDmcmahill_dot_net>]

Harold D. Skank wrote:
> Dan & Co.
> 
> I have attached all the files revelant to this problem below, i.e. the
> pcb footprint, the *.sym files from gEDA, the schematic and project
> files and a copy of the error output from the gsch2pcb command.
> 
> I VERY much appreciate any assistance on this problem.  While I don't
> see the notation in these files, in other files I have seen references
> to format #f "~:@{~A-~A ~} that you cite below.
> 
> Here's hoping this will help you find the problem.
> 
>     Harold Skank


hmmm.

I'm not able to reproduce this.

When you run gsch2pcb, try adding "-v".  You'll see that


gnetlist -g PCB -o TestOut.net Test_2.sch Test_3.sch

is called.

When I run that command by hand or as part of gsch2pcb, it succeeds and 
I see the GND net in TestOut.net.  I also tried

gnetlist -g PCB -o TestOut.net Test_1.sch Test_2.sch Test_3.sch Test_4.sch

and it also worked.

What version of guile are you using?

  % guile --version
Guile 1.6.6


How about gnetlist?

% gnetlist
gEDA/gnetlist version 20070216


All I did was save all your attachments to an empty directory and add  a 
gafrc file with

(component-library ".")

in it.


Anyone else able to reproduce the problem?

-Dan


_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user