[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: gEDA-user: Layer selection screw-up

To: geda-user-atMUNGEDmoria_dot_seul_dot_org
Subject: Re: gEDA-user: Layer selection screw-up
From: DJ Delorie <dj-atMUNGEDdelorie_dot_com>
Date: Wed, 21 Mar 2007 16:16:31 -0400
Delivery-Date: Wed, 21 Mar 2007 16:16:33 -0400
In-reply-to: <46018EDC.5030805@naic.edu> (message from Ryan Seal on Wed, 21Mar 2007 16:00:28 -0400)
List-Archive: <http://www.seul.org/pipermail/geda-user>
List-Help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-Id: gEDA user mailing list <geda-user.moria.seul.org>
List-Post: <mailto:geda-user@moria.seul.org>
List-Subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>,<mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-Unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>,<mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
References: <46018EDC.5030805@naic.edu>
Reply-To: gEDA user mailing list <geda-user-atMUNGEDmoria_dot_seul_dot_org>
Sender: geda-user-bounces-atMUNGEDmoria_dot_seul_dot_org


You could just rename the layers, then rearrange them in the order you
want.


_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

References:
- gEDA-user: Layer selection screw-up
  - From: Ryan Seal

Prev by Date: Re: gEDA-user: Layer selection screw-up
Next by Date: Re: gEDA-user: Layer selection screw-up
Prev by thread: Re: gEDA-user: Layer selection screw-up
Next by thread: gEDA-user: PCB gerber exporter question
Index(es):
- Date
- Thread