Re: gEDA-user: Layer selection screw-up

[Ryan Seal <rseal-atMUNGEDnaic_dot_edu>]

Ben Jackson wrote:
> On Wed, Mar 21, 2007 at 04:00:28PM -0400, Ryan Seal wrote:
>   
>> problem and need to move each trace to the opposite side of the board. 
>>     
>
> I did this once.  It's easy, just edit the .pcb in a text editor,
> find the block with the lines, and move them around.  So you'll
> see something like:
>
> Layer(4 "component")
> (
>         Line[239000 53000 230900 53000 2500 2000 ""]
>         Line[259000 38000 254000 43000 2500 2000 ""]
> ...
> )
>
> Just move the Line bits (or change the Layer "statement").
>
>   
It worked. I changed my layer names via emacs and then swapped my 
component-side and solder-side labels in pcb. I suppose I could have 
done this through the pcb interface (as DJ Delorie suggested) but wasn't 
quite sure and I laid down almost 500 traces before catching my obvious 
mistake - so I was a little hesitant.

Thanks again,
Ryan



_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user