Re: gEDA-user: Quick and Easy solder mask creation

[Dave N6NZ <n6nz-atMUNGEDarrl_dot_net>]

John Griessen wrote:
> Dave N6NZ wrote:
> 
>> Yes, some of them look a little odd.  But... the title says "Quick and 
>> Easy"....
> 
> 
> How should we decide to break a solder paste mask into smaller sections
> to "help them out"?   Larger than ____?  dimension?   I guess this is for
> better squeegee results -- not needing a super hard edged squeegee -- so 
> the squeegee
> doesn't go too low over a large opening and leave paste mostly in the 
> edges -- too little paste.
> 
Where is the paste mask set?  Is it computed from the pad information? 
Is there a way to include paste mask dimensions in the symbol defintion?

-dave


_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user