[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

gEDA-user: PCB: How does one restore drill sizes after havingapplied the vendor drill map ?

To: gEDA user mailing list <geda-user-atMUNGEDmoria_dot_seul_dot_org>
Subject: gEDA-user: PCB: How does one restore drill sizes after havingapplied the vendor drill map ?
From: armdeveloper <armdeveloper-atMUNGEDgmail_dot_com>
Date: Mon, 13 Aug 2007 14:30:09 -0600
Delivery-Date: Mon, 13 Aug 2007 16:30:16 -0400
List-Archive: <http://www.seul.org/pipermail/geda-user>
List-Help: <mailto:geda-user-request@moria.seul.org?subject=help>
List-Id: gEDA user mailing list <geda-user.moria.seul.org>
List-Post: <mailto:geda-user@moria.seul.org>
List-Subscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>,<mailto:geda-user-request@moria.seul.org?subject=subscribe>
List-Unsubscribe: <http://www.seul.org/cgi-bin/mailman/listinfo/geda-user>,<mailto:geda-user-request@moria.seul.org?subject=unsubscribe>
Reply-To: gEDA user mailing list <geda-user-atMUNGEDmoria_dot_seul_dot_org>
Sender: geda-user-bounces-atMUNGEDmoria_dot_seul_dot_org

How does one restore the drill sizes on a footprint after one has
applied the vendor drill map ?

How does one change the drill size on a pre defined footprint ?  

I want to shrink the drill width on the TO220STAND footprint devices.

Thanks



_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user

Follow-Ups:
- Re: gEDA-user: PCB: How does one restore drill sizes afterhaving applied the vendor drill map ?
  - From: DJ Delorie

Prev by Date: Re: gEDA-user: http://geda.seul.org/wiki/geda:faq-gschem
Next by Date: Re: gEDA-user: PCB: How does one restore drill sizes afterhaving applied the vendor drill map ?
Prev by thread: Re: gEDA-user: build of pcb-cvs fails at /usr/local/geda/pcb/doc
Next by thread: Re: gEDA-user: PCB: How does one restore drill sizes afterhaving applied the vendor drill map ?
Index(es):
- Date
- Thread