[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
gEDA-user: PCB Thermal finger width
The pcb documentation specifies that the Thermal Scale parameter
specifies the width of thermal fingers based on the annulus width.
However, I've noticed that the clearance is actually used instead.
I think that using the annulus width makes more sense. What is the
intended behavior? I'm using pcb-20070912 lesstif.
-- Daniel
_______________________________________________
geda-user mailing list
geda-user@moria.seul.org
http://www.seul.org/cgi-bin/mailman/listinfo/geda-user