[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: gEDA-user: Soldering fine pitch chips

To: geda-user-atMUNGEDseul_dot_org
Subject: Re: gEDA-user: Soldering fine pitch chips
From: David SMITH <dave_dot_smith-atMUNGEDst_dot_com>
Date: Fri, 10 Mar 2006 09:26:02 +0000
Delivery-Date: Fri, 10 Mar 2006 04:27:11 -0500
In-Reply-To: <20060310084149.GA19606@kestrel.barix.local>
Mail-Followup-To: geda-user@seul.org
References: <20060310084149.GA19606@kestrel.barix.local>
Reply-To: geda-user-atMUNGEDseul_dot_org
Sender: owner-geda-user-atMUNGEDseul_dot_org
User-Agent: Mutt/1.4.2.1i

On Fri, Mar 10, 2006 at 09:41:49AM +0100, Karel Kulhavy wrote:
> Do you think this method could be used to solder down fined pitch chips
> like 1mm 0.7mm or whatever is common today?

Whilst I preferred to solder each pin individually, my colleagues used
to use a similar technique - just cover all the pins with a big blob of
solder, then use desoldering wick to remove the excess.  These were
208-pin QFPs with (IIRC) 1 mm pitch.

-- 
David Smith            Work Email: Dave.Smith@st.com
STMicroelectronics     Home Email: David.Smith@ds-electronics.co.uk
Bristol, England          GPG Key: 0xF13192F2

References:
- gEDA-user: Soldering fine pitch chips
  - From: Karel Kulhavy

Prev by Date: gEDA-user: Soldering fine pitch chips
Next by Date: Re: gEDA-user: Soldering fine pitch chips
Prev by thread: gEDA-user: Soldering fine pitch chips
Next by thread: Re: gEDA-user: Soldering fine pitch chips
Index(es):
- Date
- Thread